EXPLORE BY TASK
Mechanical Tools
16 tools in this collection. Choose a task below or search the complete FeuTex toolkit.
Browse all tools
Bearing Basic Rating Life
Estimate basic L10 life from a supplied equivalent dynamic load.
Open tool →MechanicalCantilever First Bending Frequency
Estimate the first transverse mode of a uniform unloaded cantilever.
Open tool →MechanicalCapstan Belt Transmission Model
Estimate limiting tension ratio, transmitted power and bearing load.
Open tool →MechanicalChain Drive Geometric Link Count
Estimate pitch count and round upward to an even link count.
Open tool →MechanicalDamped Oscillator Forced Response
Find natural frequency, damping ratio and harmonic displacement amplitude.
Open tool →MechanicalDisc Clutch Uniform-Wear Model
Calculate effective friction radius and nominal torque under uniform wear.
Open tool →MechanicalFlywheel Speed Fluctuation
Estimate inertia needed to buffer specified cyclic energy fluctuation.
Open tool →MechanicalHelical Compression Spring Model
Estimate rate, deflection and Wahl-corrected wire shear stress.
Open tool →MechanicalHollow Circular Shaft Torsion
Calculate torsional rigidity, surface shear and twist for a circular tube.
Open tool →MechanicalPreloaded Joint Load Fraction
Estimate added bolt load, remaining clamp and ideal separation load.
Open tool →MechanicalRingdown Damping Estimate
Estimate logarithmic decrement and damping from separated vibration peaks.
Open tool →MechanicalShaft Combined Bending and Torsion
Combine bending normal stress and torsional shear in a solid shaft.
Open tool →MechanicalSlider Crank Position and Velocity
Evaluate exact geometric piston displacement and instantaneous velocity.
Open tool →MechanicalSolid Rotor Acceleration Budget
Estimate inertia, acceleration torque and stored kinetic energy for a solid disk.
Open tool →MechanicalSpur Gear Mesh Geometry and Loads
Calculate pitch diameters, center distance and tooth-force components.
Open tool →MechanicalSquare Thread Power Screw
Estimate raising torque, lead angle and ideal thread efficiency.
Open tool →